The Dimensional Forge
3D Print Estimate
Light Bar Floor Bracket V2.1.stl
44m
Print Time
27.1g
Filament
$0.60
Material Cost
$14.64
Total
Model Info
Bounding Box
84.1 × 72.8 × 181.2 mm
Mesh Volume
50.93 cm³
Triangles
9,824
Watertight
Yes
Fits on Bed
Oversized
Print Settings
Profile0.20mm Standard
MaterialPLA
Infill15%
Layer Height0.2 mm
Perimeters2
Quantity1
Setup15 min
Post-process15 min
Machine Rate$1.50/hr
Labor Rate$20.00/hr
Markup25%
Cost Breakdown
| Line Item | Amount |
|---|---|
| Material — PLA, 27.1 g | $0.60 |
| Machine time — 44m @ $1.50/hr | $1.11 |
| Labor — 30 min @ $20.00/hr | $10.00 |
| Markup — 25% | $2.93 |
| Total | $14.64 |
Notes & Assumptions
Material costs estimated at current market rates and may vary. Print time is an estimate based on volumetric flow — actual time may differ by ±20% depending on geometry, slicer settings, and machine calibration.
Volume computed via signed-tetrahedra method. Bed fit check assumes 180 × 180 × 180 mm (Bambu A1 mini). STL was in inches — auto-scaled ×25.4 to mm.
Pay Invoice
Secure payment via PayPal · Venmo acceptedReady to move forward? Pay your deposit or full invoice amount directly below. All major cards, PayPal balance, and Venmo are accepted.
By submitting payment, the paying party acknowledges and agrees that such payment constitutes authorization and acceptance of the scope of work, terms, and estimated costs outlined in this document. Work will commence upon receipt of payment.